SparkFun Motor Driver - Dual TB6612FNG (1A) SF_Arduino The actual current through each

The actual current through each coil changes with each microstep

Serial mode - 9600

There is also an FTDI header on board and we\'ve provided a hardware profile for the Arduino IDE to make it even easier to program

5V friendly design and only 20mA current draw

You can power the SparkFun RedStick over the USB plug or through the power input (which supports a JST connector for a single celled Lipo)

SparkFun Motor Driver - Dual TB6612FNG (1A) SF_Arduino The actual current through eachThe TB6612FNG Motor Driver can control up to two DC motors at a constant current of 1. 2A (3. 2A peak). Two input signals (IN1 and IN2) can be used to control the motor in one of four function modes: CW, CCW, short brake and stop. The two motor outputs (A and B) can be separately controlled, and the speed of each motor is controlled via a PWM input signal with a frequency up to 100kHz. The STBY pin should be pulled high to take the motor out of